![]() ![]() MUST KNOW: The COPYBASE command is very important to the AutoCAD Operator who works in disciplines such as mapping and architectural. (Select all objects using a crossing window.)Ĭommand: Figure Step 14A Figure Step 14B Figure Step 14C Step 15ĭelete the line in the center by picking it and pressing the Delete key. (Figure Step 13) Figure Step 13 Step 14Įnter the COPY command, as shown below, to copy all objects. Specify second point or : Figure Step 12A Figure Step 12B Step 13įreeze layer: Construction. Step 12Įnter the MOVE command, as shown below, to move all the circles and hexagons 0.5 inches in the positive X direction. Specify second point or : second point is set 4 inches in the positive X direction.)ĪUTHOR’S COMMENTS: I used the base point 0,0. Select objects: Specify opposite corner: 35 found (Snap to the intersection of the construction lines)Ĭommand: Figure Step 10A Figure Step 10B Figure Step 10C Figure Step 10D Step 11Įnter the COPY command, as shown below, to copy all circles and hexagons 4 inches in the positive X direction. (Snap to the intersection of the lines for the base point) (Figure Step 9) Figure Step 9 Step 10Įnter the COPY command, as shown below, to copy the circle and hexagon 4 times. Change the layer of the line you just created to layer: Construction. Using the OFFSET command, offset the left line of the rectangle 1.5 inches to the right. Using these principles in the your day-to-day work will noticeably increase your productivity.ĪUTHOR’S COMMENTS: There should be a total of 9 construction lines, 1 inch apart. If an object has to be drawn that is similar to one that was previously drawn, simply copy it and change it. In AutoCAD, objects only have to be drawn once and then they can be used over and over again even if they are in a different drawing or at a different size or orientation. Using the MOVE and COPY commands are a big part of that productivity. One of the real benefits of using a CAD program is increasing your design and drawing productivity. Fill out titleblocks in Paper space using the AutoCAD 2D book Standards.Describe how to construct a tangent arc that has one end tangent to a line and other end going through a point. ![]() ![]() Apply the FILETAB and FILETABCLOSE commands to enable the display of the open drawing file tabs above the Graphic window.Apply the MOVE, COPY, COPYCLIP, PASTECLIP, and COPYBASE commands to move and copy objects in the current drawing plus copy objects from one drawing to another.Describe how to move and copy objects in the current drawing and from one drawing to another.when you change the Z angle on the UCS, anything drawn on that plane is no longer at Z=0 when you change back.When you have completed this module, you will be able to: THe drawing elevation is usually Zero, but not always. when you change the UCS, you've just ensured that any error will be magnified because the Z is not the SAME 0, it was selected from a ZERO PLANE, not the zero point. it's using the relationship to Z=0, and that might not be where you think it is. How you guys predict it without selecting the point is beyond me. If you change USC between copy and paste, be aware that your Z-layer plane is only the same at a single point (or ray) if it's different at all. Now rotate the image and see if it is really using that point as the basepoint, or if the distance from Z is maintained. Next draw a simple horizontal line, and Then use copyclip to paste the object to the end of that line. Then view from several angles using 3dorbit to see if that line is doing what you expected it to do. ![]() Before running the copyclip, use the line command to draw a line from 0,0,0 to wherever you think your basepoint will be. Upon changing the ucs, your copyclip may not be using the basepoint you think it is. ![]()
0 Comments
Leave a Reply. |